Pitney-bowes W680 User Manual download pdf (Page 34)

3-6 Pitney Bowes W660/W680 Operator Guide

3 • W660/W680 Basics

Switching from one material type to another requires setting the

gap between the separators and the feed roller before printing

begins. To find the correct spacing, refer to the figure on the next

page and follow the instructions below:

1. Loosen the lock knobs to unlock all three H-Blocks.

2. Lift all three H-Blocks to their highest position and lock

in place.

3. Place a sample piece of material into the input area.

Align the sample with the left wall of the input area, then

place it between the separator fingers (the lower section

of the H-Blocks) and the feed roller.

4. Lower only the H-Blocks that come in direct contact with

the sample material. Make sure the material is between

the separator fingers and the feed rollers, and that the

separator fingers do not directly contact the feed rollers.

The following procedure describes the steps for setting up a

job.

1. Set the Separator Gap

Setting Up A

Job (continued)

for detailed instructions. If you have the W660/W680 print driver

loaded on your computer, you can easily perform these functions

from within your application.

10. OutputStacker Tray

Printed material is deposited in the stacker (catch) tray. The tray

holds about 5" of material.

11. Output Area

Where printed material is ejected from the printer.

12. Exit Rollers (Not Shown)

Guides the printed material as it exits the printer. Adjust so that

each roller overlaps the edge of the material by 1/4".

13. Transport Door

Open to gain access to the print cartridge and exit rollers.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 129 130

No comments

Pitney-bowes W680 User Manual Page 34